Oscilloscope Accessories
Optional software packages for controlling an oscilloscope's functionality/parameters via PC and carrying cases specifically designed for porting equipment from area to area are all available in this category.
Find out more about Oscilloscope Accessories below.
- GPS antenna
- SMA(M), 100cm
- Suitable for the SHA850A Series
- Suitable racking plate for the RM300/RM300A
- Not recommended for use as a battery charger
- Rack blanking plate
- Suitable for RM410
- Not recommended for use as a battery charger
- Additional/Replacement Universal AC Adaptor
- Suitbale for the PSA Series 2 or 5, TF930/960 and, I-prober 520
- AC-DC adapter
- Suitable for the SHA850A Series
- Type B
- 5.0V/2A
- For use with Aim-TTi's PSA Series 2 and 5 Analysers
- 2GHz bandwidth
- Male N-to-BNC cable
- 0.7m (27.6 inches) in length
- Adds temperature measurement
- Dual input temperature adapter
- 10M Ohm input impedance
- For use with Aim-TTi’s PSA Series 2 and Series 5 Spectrum Analysers
- Determine the frequency of RF sources
- Take relative measurements of amplitude
- 30V CAT II rated
- Suitable for the 120/190 Series
- Safety designed
- Two adapters in a pack
- Female BNC to shielded banana adapter
- Passive oscilloscope probe
- Suitable for use with the 350MHz models
- Store and transport
- Portable bag
- Suitable for the SHA850A Series
- USB connector adapter
- Suitable for use with the Fluke 120B Series ScopeMeters
- Black, red & grey clips
- Nickel-plated steel jaw contact material
- Designed for use with STL 120 Shielded Test Leads and TL75 Test Leads
- Detachable external pouch
- Dimensions: 10 x 5.2 x 1"
- High-quality SMA terminated cable has low-loses of up to 6GHz
- SMA to N-type adapters for connecting the PSA to a generator
- BNC to N-type adapters for use with BNC cables
- High quality
- Specifically designed for Aim-TTi
- Not recommended for use as a battery charge
- Soft carry case
- Store and transport Aim-TTi’s PSA Series 2 & 5 Spectrum Analysers
- Passive oscilloscope probe
- Suitable for use with the 500MHz models
- Allows for hands-free operation
- Suitable for the ScopeMeter Series 190 II
- Soft carry case
- Suitable for the SDS2000X, SDS2000X Plus, SDS5000X, SSA3000X, SVA1000X, SSA3000X-R, and SSA3000X Plus models
- DC bias out option
- SMB(F), D12V-32V,0.1V step
- Suitable for the SHA850A Series
- Consists of two adapters
- Male BNC to dual female BNC T-piece
About Oscilloscope Accessories
Oscilloscopes are powerful and flexible test instruments. To further exploit the range of tests available to electrical test engineers, lab technicians, or automotive engineers, there is a whole load of accessories available including probes and probe sets, adapter plugs, break-out adapters, and spare battery packs for hand-held models.
If you need to convert from BNC to a banana plug or measure voltage drops with a current shunt you will find the cable or sensor adapter here at Tester.
You may already have amassed a fine collection of accessories so why not keep them in a purpose-built carrying case? This will keep your meter and accessories together and ensure that you're always ready to go on a job wherever it may be.