Cable Avoidance & Fault Location Accessories

• Low-frequency signal is transmitted through metal pipe walls
• Trace metal pipes and located blockages up to 5m below the ground
• Small, self-contained and specifically designed for use in metal pipes

• Live cable connection
• Connects to Genny products
• 440Vrms and CAT III rated

• Cable detection depth of 100m/4"
• Locate and trace the path of a specific utility
• Operates at 33kHz

• Suitable for the R series
• Submersible Antenna Adaptor

• GPR Battery Cable
• Suitable for the RD Series

• Ppack of 10
• Internal Filter
• Authorised Use Only

• Drill Extension Bar
• Suitable for the CableSniffer

• 38mm diameter
• Depth range 5m
• Trace the route of drains, sewers, plastic pipes, and ducts

• Small diameter to prevent snagging in ducts and conduits
• Trace and find blockages in electrical, telecommunication and cable conduits and ducts
• Robust and weatherproof to IP65

• Trace narrow, non-metallic pipes
• 20m tracer with Sonde technology
• Developed specifically for the British gas industry

• Find, follow and avoid buried insulated cables
• Wide, 100mm diameter
• No need to remove the conductor’s insulation

• Can be used with extension rod
• Apply a transmitter signal to a specific cable or pipe

Can be used to apply a transmitter to live cables using a standard mains socket.

• Battery-operated
• 33kHz signal
• Connects to FlexRod

Fibreglass rod used for tracing pipes and ducting. It is used to propel sondes. 50m

• Rechargeable Li-Ion battery
• Convenient and cost-effective alternative to alkaline batteries
• Available with either an auto charger, a mains charger, or a mains and auto charger

This clamp is used to apply a transmitter signal to a specific cable or pipe. This is particularly useful where direct connection is not possible, or on live cables when these cannot be de-energized. It can be used with the extension rod. (2" 50mm)

• Locate individual utilities
• Small size and flat surface

• Attach to drain rods and other movable tools optimised for use inside non-metallic pipes
• Small, self-contained, battery operated and waterproof
• Ideal for drainage contractors and builders

• A convenient alternative to batteries
• Transmitter Mains Power Supply Unit
• Powers the transmitter directly from the mains

Fibreglass rod used for tracing pipes and ducting. It is used to propel sondes. 50m

• 25cm
• Searcher Bar
• Suitable for the CableSniffer

BT Rodding Oscillator.

• Internal Pump
• Suitable for the CableSniffer
• Authorised Use Only